# changelog

author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 2.4.4-5
changelog:
  - Initial package
   - Fixed panics when the driver is loaded on 8257x and 80003es2lan non-copper devices (Severity: Critical)
   - Fixed slow performance experienced by ICH9/ICH10 interfaces with 9K Jumbo
   - Fixed EEE in Sx power consumption higher than LPLU


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 2.5.7-4
changelog:
  - Fixed panic with Rx traffic while interface is going down
   - Add support for I218 "Ultra-Low Power" (ULP) mode enabled in S3/4 and in S0 when Runtime Power Management (RPM) is enabled
   - Fixed multiple Runtime Power Management (RPM) issues
   - Fixed a Tx hang inssue at 100Half on I218
   - Fixed numeric overflow in phc settime method
   - Fixed issue of AMT connection drops after driver unload if large MTU configured
   - Fixed low throughput issues and high CRC error count issues using 4K jumbo MTU
   - Fixed vlan support issues for kernels 3.10 and above


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 3.2.2.1
changelog:
  - Added SLES 12 support
   - Added RHEL 6.6 support
   - Fixed the issue of interface not receiving traffic when there is no cable attached.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 3.2.7.2-1.all
changelog:
  - Added SLES12SP1 support
   - Added RHEL 7.2 support
   - This driver corrects a issue where the unit becomes unresponsive during a hardware reset.
   - This driver corrects a transmission hang seen during diagnostics, which makes the network adapter unusable.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 1.3.46-2.all
changelog:
  - Added support for SLES12SP1
   - Added support for RHEL 7.2
   - This driver addresses an issue where firmware version information reporting is incorrect and inconsistent.
   - This driver now correctly sets the default value of the Flow Control setting after a device reset.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 1.2.33-1
changelog:
  - Initial release of i40evf driver to support Intel(R) 40 Gigabit Adapters based virtual function devices that can only be activated on kernels that support SR-IOV.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 1.3.33.2-7.all
changelog:
  - Added support for SLES12SP1
   - Added support for RHEL 7.2
   - This driver addresses an issue where Virtual Function (VF) VLAN stops working if the device Physical Function (PF) is changed to Promiscuous Mode.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 5.0.7-10
changelog:
  * Wed Nov 27 2013 HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 5.0.7-4
   - Fixed igb compilation issues with upstream 3.10 Linux Kernel
   - Changed how driver update rx packet stats, to include additional packet types
   - Add support for freeing q_vectors via RCU


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 5.2.17-2
changelog:
  - Added RHEL 7.1 support
   - Fixes a Tx Unit Hang on Network Adapters based on Intel 82576 chipset(NC362i) with RSS > 1


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 5.3.3.2-4.all
changelog:
  - Added SLES12SP1 support
   - Added RHEL 7.2 support
   - Fix queue allocation method to accomodate changing during runtime
   - Use skb_vlan_tag_* functions instead of old name vlan_tx_tag
   - This driver addresses an issue where the link speed reported by the HPE Active Health System (AHS) is incorrect.
   - This driver can now correctly change the queue allocation method during runtime.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 3.15.1-5
changelog:
  - This driver now supports SRIOV virtual functions
   - This driver now supports HP Ethernet 10Gb 2-port 561FLR-T Adapter
   - This driver now supports HP Ethernet 10Gb 2-port 561T Adapter
   - This driver now supports HP Ethernet 10Gb 1-port P560SFP+ Adapter


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 3.19.0.46-4
changelog:
  - Fixes kernel panic which occur when sending traffic through vlan with latest stable and cvs
   - Add support for dumping SFF data from the SFP modules
   - Fixes TX hangs on kernels with BQL enabled and ITR>100K/sec
   - Fixes TX hangs which used to occur when Interrupt Throttle Rate(ITR) is disabled with IP forwarding enabled.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 3.22.0.2-10
changelog:
  - Added support for Live Error Recovery(LER)
   - Fixes issue of driver getting hang while using netconsole with busy poll


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 3.23.0.79
changelog:
  - Added SLES 12 support
   - Added RHEL 6.6 support
   - Fixes the issue of TX Unit hang which occurs when re-plugging of  network cable while passing traffic on VMs(using VFs)
   - Fixes incorrect reporting of sriov values under sysfs
   - Fixes the issue ixgbe driver causing keyboard delay when DAC Cables are used


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 4.0.3-1
changelog:
  - Added RHEL 7.1 support
   - Added SLES11SP4 support
   - Fixed the issue of VXLAN offload tx-udp_tnl-segmenation not getting enabled
   - Made changes to use dma_rmb when accessing RX descriptors.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 4.1.5-3.all
changelog:
  - Added SLES12SP1 support
   - Added RHEL 7.2 support
   - Used new skb_vlan_tag_* functions instead of old vlan_tx_tag_* functions.
   - This driver addresses an issue where the link speed reported by the HPE Active Health System (AHS) is incorrect.


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 2.12.0.38-10
changelog:
  * Wed Nov 27 2013 HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 2.12.0.38-4
   - Fixed the issue of SLES 11 SP2 VM guest unable to change hardware offload settings for VF interface
   - Correct support for NDO features in VF
   - Correct build if HAVE_LVAN_RX_REGISTER not defined
   - Fixed the driver hang issue when rmmod is done on RHEL 5.9 Guest opearting systems
   - Support for bus poll sockets


author: HP Linux SW Deliverables <Linux_SWdeliverables@external.groups.hp.com> 2.16.0.43
changelog:
  - Added SLES 12 support
   - Added RHEL 6.6 support
   - Added netconsole/netpoll support for Virtual Function interface
   - Fixed vlan support issues on linux kernels >= 3.10 which was broken due to recent kernel changes
   - Fixed issue of ifconfig TX stats incrementing without traffic present on VF interface
   - Fixes the issue of TX Unit hang which occurs when re-plugging of  network cable while passing traffic on VMs(using VFs)


